The first is the parameter setting problem. When the woodworking engraving machine is positioned in the Z axis, it is not to let the knife touch the material surface, but to remove the material so that the knife directly touches the table. It can be touched, not deep, in this place Z The axis is first zeroed, and then the corresponding height is raised according to the cutting depth set in Venter, where the Z axis is zeroed again. This is the origin of the Z axis. According to the depth of the setting of Wentai, the lowest point of the engraving machine is the first place where our door is zeroed, just above the table top, which ensures that the material is completely etched without hurting the engraving machine table. Secondly, it is best to add a protective plate on the surface of the engraving machine. For example, the woodworking engraving machine with vacuum adsorption table can put a thin Ozon plate on the table. The looseness and permeability of the Ozon plate itself will not affect the vacuum adsorption capacity, and it is also effective to avoid. Tool damage and table problems caused by inaccurate origin settings. Even if the above-mentioned treatment of the woodworking engraving machine is used in the long-term use, it will inevitably cause scratches and scratches. At this time, it is necessary to re-mill the platform surface. When the electric board or PVC on the table surface is too thin, It is ok to re-lay a layer. In addition, it should be noted that in order to prevent damage to the countertop during the transportation and transportation of the machine, it is generally necessary to re-mill the platform when the after-sales personnel install and debug.
