Match your engraving machine to a suitable workbench
People are always satisfied with the various popular engraving machine workbench currently on the market. As everyone knows, in some respects, there is always no convenience for standard woodworking equipment. There is one thing you have to drill
Adjust the height of the cutter to the bottom of the table, replace the milling cutter, and open and close the power switch. The convenience of the ultimate engraving machine can be compared with the table saw - the common operation and adjustment can be engraved
The unit consisting of the machine and the accessories is taken out from the workbench and placed on the workbench for adjustment. Of course it contains dust collection capacity and shock absorbing structure.
The company has proposed a scheme for engraving the cabinet. It can meet the above requirements and is very quiet when working. This design relies on the JessEm Router-R-Lift engraving machine lift.
The engraving machine lifting device is a mechanical device for adjusting the height of the milling cutter by driving the engraving machine by the screw. The user only needs to insert the wrench into the wrench hole on the table of the lifting device to realize the above work.
can. The JessEm lifting device costs $200. Adding a pad, I can raise the engraving machine to the maximum height and then replace the milling cutter on the work surface.
The biggest advantage of this engraving machine table is the simple components and smart functions. The cabinets are all made of thick medium density board (MDF) in the form of removable fasteners. Under the workbench
The front and rear side panels support the engraving machine insert and have a dual dust collecting passage. There are two dust collecting ports on the periphery of the lifting device, and the filter box is next to the lifting device. This structure has an efficient dust collecting function.
Place the finished work surface on the sub-frame frame to form a complete system. This structure can pack both the vacuum cleaner and the tube, and the engraving machine and the vacuum cleaner emit themselves.
The noise is also suppressed. The dust collecting channel is located below the workbench and behind the lifting device. The backing system with the dust collecting channel is used in conjunction with the work surface.
The only essential thing in installing the engraving machine is to insert a precise square groove in the engraving machine table so that the inserting plate of the lifting device is embedded. First put the work surface flipped over
On the table, then from the front edge of the engraving machine workbench, offset 3 inches backwards as the grooved reference line, align the front edge of the embedded board with the reference line, and then insert the board with the MDF strip.
The circumference is tightly closed, and the MDF is fixed on the table with screws. Be careful when screwing the screws. Do not screw too deep to avoid damaging the upper surface. Medium density will swell in a humid environment,
To avoid over-tightening the insert plate, tape the paper around the insert plate before using the MDF strip to wrap around the board. These strips will be the backdrop for your slotting and trimming machine.
The jigsaw is cut along the guide bars, and the remaining trimming machine is used to straighten the tape and the tape paper is removed to complete the slotting work. Use a 3/4 inch diameter milling cutter to form a 3/8 inch radius fillet at right angles
An insert plate with a lifting device.
